|
HDD Regenerator 1.51 - User Guide and FAQ
Screenshots - More Details
After you start the Console Application
- Choose the drive to regenerate
- Enter the "Starting Sector" parameter. Leave this parameter
equal to 0 if you want to scan the entire disk. Enter the sector value
if you want to scan the disk not from the beginning. For example, you
don't want to scan the first 5 GB of your hard drive to save time,
because you know that this part of the surface does not contain bad
sectors. In this case enter the offset equal to 5000 with 'm' following
or 2560000 without 'm' following (number of sectors 5000x512=2560000)
- Wait while the scanning is completed. If you use the unregistered version,
you'll receive onscreen report about the possibility to regenerate your
disk by means of the registered full version. If you use the registered
version you can find the report about regenerated sectors in the
hddreg.log file.
Screenshots - More Details
|
